When a dual-band router suddenly drops its 5 GHz network, connected phones and laptops fall back to the slower 2.4 GHz band. Video calls stutter, then recover minutes later on a different channel. The router’s event log often shows the word “RADAR,” which is Dynamic Frequency Selection at work. The feature makes the router yield to military radar, satellite communication and weather radar, which have priority on large parts of the 5 GHz band, according to ASUS.
Government rules behind the handoff

In the United States, Federal Communications Commission rules govern how a router behaves on shared channels. Before transmitting, it must listen for radar for 60 seconds. If it detects radar during a session, it has 10 seconds to stop transmitting and must stay off that channel for at least 30 minutes. DFS is enabled by default, and the FCC requires it to remain on in the shared bands.
The radar most likely to interrupt a home network

Military radar is not the usual culprit for a US home network. Airport radar is. The Federal Aviation Administration operates 45 Terminal Doppler Weather Radar systems protecting 46 of the country’s busiest airports, including JFK, O’Hare, Dallas and Denver. These systems detect wind shear, a sudden and potentially dangerous change in wind speed and direction that has historically caused aviation accidents during approach and departure. They transmit between 5600 and 5650 MHz, in the middle of the 5 GHz Wi-Fi band. According to the FAA, no wind shear accident has occurred at a TDWR-protected airport since the system was commissioned in 1994.
In early 2009, the FAA began detecting interference to those radars from unlicensed 5 GHz equipment, prompting a joint investigation with the National Telecommunications and Information Administration. Enforcement followed. In August 2019, the FCC proposed $25,000 fines against three wireless ISPs — Boom Solutions, Integra Wireless and WinPR — after their equipment interfered with the weather radar at San Juan International Airport in Puerto Rico. The FCC said each company had turned DFS off. WinPR’s penalty was confirmed that November and Boom Solutions’ in early 2020. Those were outdoor point-to-point links rather than home routers, but they illustrate why manufacturers cannot simply remove a feature that annoys customers.
What happens when radar is detected

The 60-second listening period occurs each time a router starts up on a DFS channel. That is why 5 GHz can take longer than 2.4 GHz to reappear after a restart. ASUS says the wait can range from one to 10 minutes depending on the country. The upper end applies in Europe, where the ETSI standard governing 5 GHz Wi-Fi requires a 10-minute check on any channel overlapping the 5600 to 5650 MHz weather radar slot.
If radar is detected mid-session, the router exits within 10 seconds and locks out the channel for 30 minutes. FRITZ! says its routers steer connected devices to 2.4 GHz during the wait, seamlessly for devices that support the 802.11k and 802.11v roaming standards, and by briefly dropping the connection for older devices. ASUS notes that a radar hit on a 160 MHz channel can push the router down to 80 MHz, and that a router set to a fixed channel will not move back once the radar goes away.
Using DFS channels and the cost of disabling them
DFS channels are legal, enabled out of the box, and make up most of the 5 GHz band. In the United States, only channels 36 to 48 and 149 to 165 are radar-free. The trade-off is occasional interruptions for people who live near an airport or military base. FRITZ!’s threshold is radar detected continuously or every hour, at which point it recommends pinning the router to channels 36 to 48.
ASUS provides instructions for disabling automatic DFS channels, and those instructions also tell users to untick 160 MHz channel bandwidth, because the widest 5 GHz channels cannot be built without the radar-shared spectrum. Turning DFS off therefore adds some stability at the cost of losing the fastest 5 GHz connection the router can offer. These settings usually sit under the 5 GHz wireless menu, alongside options used to improve router security.
